V
13
Configuring the Actiontec Wireless Access Point
Access Points within range, whether they have been configured properly or not.
3. In the ‘Select wireless ethernet device’ dialog, select the Actiontec Wireless Access
Point you want to configure from the list. Once the Actiontec Wireless Access
Point is selected, click Next to continue.
If the Access Point you are looking for does not appear in the list, click Rescan.
The Actiontec Wireless Access Point Configuration Utility will search for the
Actiontec Wireless Access Point again. For example, use this to find Access
Points that have just been switched on or reset.
These devices may take up to a minute to find the Access Point’s IP address, and
they will not appear in the list until then. If the device that you want to manage
is not in the list and is not found after clicking the Rescan button, refer to the
troubleshooting guide for help.
4. Once the ‘Actiontec Wireless Access Point Configuration Utility Ready-to-Start’
window appears, you are ready to start the Web Interface. Click on Finish to
continue.
Comentarios a estos manuales